Just finished building the Mini Zero with the new Maker 2 foam board. It turned out great! Definitely a better design than the Mini Mustang I built a few months ago. Thank you John Overstreet! The build was enjoyable, and I found it easy to follow along with Josh's video. And the decal sheet that comes with the quick-build kit is a nice addition. I did note two exceptions during the build, though. For the aileron servos, Josh recommends using the heavier 4-prong servo arm and trimming off 3 of the prongs. None of the servos in the "F" powerpack that I bought included the 4-prong version. However, there was a 2-prong version that is heavy enough. Also, routing the servo wires through the guide tubes in the rear fuselage (exactly as marked on the foam board and shown in the video) put way too much bend in the wires. I'm confident the rudder and elevator servos would not have handled that much resistance for long. Ultimately, I cut open the belly and removed the guide tubes. Now the wires run through the holes in the fuselage former and straight out through the back of the fuselage -- no more binding. All painted and ready to maiden as soon as I get a calm, dry day.