Image 1

Linkage Stoppers 6 pack

0.30 LBS
Calculated at checkout


Related Products
Product Videos
Also Viewed
By Category
Other Details
  • Product Description

    6 pack of linkage stoppers designed for 1mm push rods.

  • Product Reviews


    Write A Review

    1. work great !

      good price ! fast shipping ! on 6th Mar 2017

    2. Must have

      I bought these after watching FliteTest build videos. They make adjusting your control quick and easy. Every servo should have one of these. on 14th Jan 2017

    3. Great product

      They don't quite fit the control arms in the f power pack with out drilling. Other than that great! on 25th Dec 2016

    4. Good quality product

      Work great, fit the pushrods off the site, but they do require a little drilling (5/64 bit worked for me) on the control arm of the servo in order to fit. Remember to glue on the nut. on 12th Dec 2016

    5. A Good Timesaver

      So far, no issues with them. I do use hot glue on the nuts to be on the safe side. They do make slight adjustments to control surfaces easy on 12th Dec 2016

    6. Small but very effective.

      I think it is one of the best things for allowing adjustment of the control rod and surface. on 1st Oct 2016

    7. Great tool in building planes.

      I use these on all my foamy builds. They work great for setting neutral on your control surfaces. They are a bit larger than the flite test holes on the control horns and servos so you will have to drill out the holes slightly but that's about it. Definitely recommend grabbing a few sets if you plan on building lots of planes. on 30th Sep 2016

    8. So far so good

      I put these on my superbee (against the advice of Josh in the build video) so that I could adjust my trim easier. So far they have worked out just fine, though I did put a dab of hot glue on the set screws and the nut to keep them from loosening up. Loctite should also work.

      I'm deducting 1 star because they are a little bit tough to install since the stud that goes through the control horn is considerably thicker than servo wire. That means the control horn needs to be drilled out. Another issue is when you tighten the nut all the way down, it pinches on the control horn which means it can't pivot correctly. I guess these are meant to be installed loose, but the nut would easily fall off if not loc-tite'd or glued in place.

      I don't know if I saved any time on the initial install, but I do have the option to adjust them easily later.
      on 9th Sep 2016

    9. Easy timesaver

      Get them, use them. better than a PBJ sandwich on 11th Aug 2016

    10. Great product

      These are a real time saver and make adjustments easy. The foam planes we build for combat rarely stay in trim with weather changes and these really make changes simple.
      I also pylon race EF1 and AMA 424 quickee planes and these are not suitable for that type of application but are great for the small lite planes Flite Test sells.
      on 6th Aug 2016

  • Warranty Information


  • Find Similar Products by Category