Flite Test

Power Pack D (Hexacopter)

$138.00 $135.50
You save: $2.50
Current stock: 0

Contains everything needed to power An Electrohub Hex or y6 copters. (Power system only. Transmitter, receiver, batteries, charger, flight controller, tail servo sold separately). This set up is designed to be used with a 3s Lipo battery but is also rated to be used with 4s with smaller props equipped. 

We have put together this power pack with all motors that have standard threads (righty tighty, lefty loosey), which is the new STANDARD in the multi rotor industry. We also included lock nuts in which we have personally spec'd out specifically to enhance the multi-rotor durability and overall experience.  These lock nuts allow the bolt to pass through the nylon washer.  This enhances the ability for a tighter grip and allows the motor to spin without fear of having your nut flying off and cause damage to your multirotor.  These Nuts are included along with the stock fasteners.

Note: No power distribution included. If you intend to use this with something other than our Electrohub, you will need a separate power distribution solution. 

Note: Included EMAX ESC's may not work with Pixhawk flight controllers. 

Pack Includes:

  • (6) Motors - Emax 2213-935kv (CW Threaded Shaft)
  • (6) ESCs - BL Heli 20 amp XT-60
  • (6) M6 Aluminum Lock nuts - (Standard/CW threaded)
  • (6) Propellors - 10x4.5 CW
  • (6) Propellors - 10x4.5 CCW 
  • (1) Battery Lead - XT60
  • (1) FT Allen Driver
  • (1) FT Screwdriver

Reviews (2)

Allan Aylard 10th Mar 2017

Excelent value

Seems to be a good value. I would not suggest this power pack if the prop needs to be installed in a pusher configuration (Y6). The motor/prop mating configuration is not suited well for a pusher prop configuration. I wish I knew this before I ordered it. If you are using this pack on a normal hexcopter it should be a very servicable package.

jjyellowtruck 5th Aug 2015

Almost Perfect

Nice power, quiet and works out well with the dragonfly. One problem: One of the ESC's came with a JST connector which had to be replaced with 16ga wires. Haven't used it yet, hope it works.