Does not fit the Inductrix FPV +
Looks nice & seems like it would be worth getting, if you have the compatible model.
Put this on my Inductrix BNF with stock motors, makes it 20x stronger. The flight time stays at 4:10 with a 20 second reserve on a 200 mAh 35c Crazepony battery. Stays on well, just a dab of hot glue makes it semi-permanent. Much better than buying $8 replacement frames.
I put this on my lightened Inductrix FPV and it brought the weight back up to 20.78 grams from 19.92 grams. My flight times have dropped to 2:45 from 3:30. I wedged a tiny(very tiny, size of a pinhead) piece of 3M clear double sided tape between the brace and each motor. It sits snugly and level at the bottom of the battery holder. The stiffness it adds was much needed and it is more predictable and smoother in flight which makes it easier to race. I can't attest to any improvement in crashworthiness as I haven't had a bad crash with it as of this review(only had it a few days). The carbon fiber looks to be of good quality. I'm thinking about sanding it down to half thickness to save weight. I don't really know about recommending this piece. The loss of 45 seconds of flight time and a little agility hurts a lot, but on the other hand, it does quicker lap times and looks really cool. It's a toss up.
Update 5-1-2017: I have tinkered with my Inductrix FPV a lot more and have the weight down to 20.00gms with this on. I drilled some very small holes in it to reduce weight. It has regained it's 3:30 flight times(with Lynx "special sauce" motors) and can't be beat by any of my friends' tiny whoops. It looks even more high-tech and with the "stage 3" motors, is INSANE!
Purchased 2 of these LUV "Em!! I'm flying an Inductrix frame, Special Sauce Motors, and a Stinger Cam. The brace adds .7 grams to my craft. If you flew an E010 frame, for the strength, you would add 2 grams more. I have them hot glued level with the bottom of the battery tray. They do not move and hold the legs tight. I have been flying the same frame for 2 months. Used to, if lucky get a week out of 'em.
Love it. The stock frame is way to flexible, this CF brace makes it much better, and only adds .4g extra weight. Not sure the problem the other reviewers are having below. It sticks to my frame fine and stays put with a little coaxing and maybe a dot of hot glue.
I shred with my whoop outside. Indestructible with this brace.
19000kv motors,
Beebrain,
205mah MyLipos
Upon first installing it I was disappointed in how loose it was one my Inductrix fpv. But after removing a little bit of plastic on the rear of the frame near battery I find that stiffener slides all the way up to bottom of the frame. Once I did that I was ecstatic about how well the stiffener remained up against the frame. It does add some weight which you do notice in punch out, and its handling. I feel that it is worth it as it has saved me a ton of frames. I will not causally fly with out this stiffener.
Bought 2 of these for both of my Inductrix. Way to loose. Very poor fit. Do not recommend.
Not a good upgrade, put this on and it doesnt sit straight at all and comes loose way to often. Also decreased flight time to about 1 min and also cant recover as quickly when its on, when u punch or lift off the quad struggles. Wasted money, i would not recommend.