Hobbywing XRotor 20A Micro Brushless Drone ESC

Low Price: $13.99
Back Order Save In List
Out Of Stock Online
You may back order this item and it will ship when it arrives in stock.

Please Log in to receive a notification when this item arrives in stock.

This is the Hobbywing XRotor 20A Micro Brushless Drone ESC.


  • Super Small & Light architecture
  • F396 48MHz MCU
  • Premium MOSFETs (Toshiba MOSFETs for 20A & 35A ESCs, Fairchild MOSFETs for 30A ESCs)
  • Ceramic capacitors
  • 3-in-1 drive ICs, 3-ounce copper
  • Ultra high efficiency & rapid response - 4 layers of PCBs and other quality components guarantees less heat.
  • BLHeli Firmware Ready - Users can flash or upgrade the BLHeli firmware via the signal cable (on ESCs), and program 4 ESCs simultaneously after connecting their flight controller to the BLHeliSuite software if the flight controller uses the CleanFlight firmware
  • Damped Light Mode & OneShot125 Mode Supported
  • Damped light mode improves the motor retardation and allows users to brake the FPV drones more efficiently. Active-freewheeling technology improves driving efficiency, flight time and heat dissipation.
  • Support OneShot125 high speed throttle signal and regular throttle signal (within 500Hz) modes.
  • ESC + Motor combo available

FPVs with 130-280mm Diagonal 
LiPo Power input: 2S-4S    
Continuous Current: 20A
Burst Current: 30A
BEC Output: NA
Input wires: 20AWG-100mm* (Red/Black)
Output Wire: Solder tabs (no wires)
Connectors (In/Out): no
Weight / Size: 7g / 24.0x13.9x5.5mm
*Note: All the wire length above is the original length, not the length you see from the outside.

This product was added to our catalog on December 1, 2016