Flite Test

FT Spear

$40.00 $36.00
You save: $4.00
Current stock: 0

We finally get to welcome the FT SPEAR to the FT plane family!!  You can fit it all in the new FT SPEAR!  This plane was designed to be able to carry all your gear when you fly!  you can put your GoPro, board camera, 2 batteries, fpv gear, and even a vector system, if you have one.  Also, if you have seen the episode it EVEN HOLDS chipotle chips, guac and a BURRITO!! haha  The Spear has a unique center console that is made larger and wider for the very purpose for storage.  The larger wing allows for a larger payload compared to the FT Mini Arrow!  This wing also allows for you to strap/tape bendable tripods with cameras for different ariel viewpoints if you are trying to get that epic shot!  The Spear also is super stable and allows you to perform acrobatically challenging maneuvers with ease!  

Thank you for you for your support by picking up an FT Spear and PLEASE make sure to let us know what you think!  We always love your feedback! 

NOTE:Every purchase of the spear will include a NEW FT Sticker set (7 piece set)


  • 1x FT spear Foam Kit
  • 1x Wood accessory kit
  • 1x FT 7-piece sticker pack


  • WEIGHT WITHOUT BATTERY: 1.45 lbs (658 g)
  • CENTER OF GRAVITY: 3 – 3.5” (76 – 89 mm) in front of firewall
  • CONTROL SURFACE THROWS: 16 ̊ deflection – Expo 30%
  • WINGSPAN: 41 inches (1041 mm)
  • RECOMMENDED MOTORS: 425 sized 1200 kv minimum
  • RECOMMENDED PROP: 9 x 4.5 CW (reverse) prop
  • RECOMMENDED ESC: 30 amp minimum
  • RECOMMENDED BATTERY: 2200 mAH 3s minimum
  • RECOMMENDED SERVOS: (2) 9 gram servos 

FT Spear - Build | Flite Test

Please watch recent build videos before removing any paper from the foam! Some videos may use white foam board, which is no longer available and has now been replaced with water-resistant foam board.


Reviews (15)

2nd Nov 2016

Great Build Experience, Thanks Josh

Wonderful wing with loads of room to electronics and a great build experience. Thanks FT

Lance 21st Oct 2016

Great first time build

My first venture into the flite test store and speed build kits, this model was built fairly easily over the course of a few hours a day. My only issue was that the propeller that came in the suggested power pack was about half an inch too long on either side of the wing, so I had to remove a chunk to allow the propeller to pass freely. Make sure you get your CG right, as mine was a little unstable on my first flight and I eventually plowed into the dirt and crunched the side of the nose.