This is an EMAX 12 Amp BLHeli ESC, intended for Airplanes, Helicopters, & Multirotors.
- BLHeli Firmware for ease of use, and crisp throttle response
- Low voltage protection
- Over temperature protection
- Self-check functions
- Separate power supply for MCU and BEC, enhancing the ESC's ability of eliminating magnetic interference
- Parameters of the ESC can be adjusted via BL Heli Suite
- Throttle calibration possible through Transmitter, BLHeli Suite, Baseflight, and Cleanflight
- Equipped with built-in linear BEC
- Max speed: 210,000 RPM for 2-pole, 70,000 RPM for 6-pole, 35,000 RPM for 12-pole
Input Voltage: 1-4 cell, 1s-4s LiPo
Constant Current: 12 Amps
Burst Current: 15 Amps
Dimensions (LxWxH): 26x20x7mm
Motor Wire Length: 47mm, 20awg
Battery Wire Length: 72mm, 20awg
Throttle Wire Length: 257mm
ESC BEC: Built-in Linear BEC
BEC Output: 1A/5V
Weight (including wires): 10g
- Flite Test Alpha
- Flite Test Alpha Bravo Charlie
- Flite Test Bravo
- Flite Test Charlie
- Flite Test Glider Golf Kit
- Flite Test Long EZ
- Flite Test Mini Arrow
- Flite Test Mini Corsair
- Flite Test Mini Cruiser
- Flite Test Mini DR1 Triplane
- Flite Test Mini F-22
- Flite Test Mini Mustang
- Flite Test Mini Pun
- Flite Test Mini SE5 Biplane
- Flite Test Mini Scout
- Flite Test Mini Sparrow
- Flite Test Mini Speedster
- Flite Test Mini Sportster
- Flite Test Mini Tiny Trainer
- Flite Test Mini Vector
- Flite Test Mini Warbird Combo
- Flite Test Pietenpol
- Flite Test WWI Battle Buddies
As for the EMAX ESC, I was very disappointed. I purchased two of these devices. On the plus side, they were the perfect form factor for my project. The first ESC I installed seemed to work fine, it calibrated ok, it throttled up fine, but after about 30 seconds of runtime, it cut out and reset. I checked my setup, and tried again, same thing. Tried one more time and the controller burst into flames. Not expected behavior.
Ok, I can see that maybe it was just a defect controller, so I replaced it with the second one. Checked the connections, Calibrated it, throttled it up, and it seemed to work. Tried to go flying. Throttled it up, took off and the controller cut out again and reset. It did the same thing as the first, without the flames this time.
Just to make sure I wasn't doing something wrong, I swapped the controller with another manufacturer (US). The plane works fine and I'm still flying with the other(US) controller.
I really can't recommend this ESC based on my experiences. I bought it because it was inexpensive and it was recommended, I guess you get what you pay for. Sorry.
The second is on a custom half sized FT Explorer with a no brand 1806, running 2 and 3s, but only powering 2- 2.5g servos with no issues. I think they are great escs as long as you don't ask to much from them.